HP ECU for G400C

Our very own Thumper!
Post Reply
User avatar
wheelbender6
Member
Posts: 852
Joined: Sun Jul 07, 2013 1:27 am
Location: Houston area

HP ECU for G400C

Post by wheelbender6 »

Genuine riders rejoice. Magnum now offers a performance chip for theG400C, errrrr, Mash 400 Scrambler. (So check your connectors for compatibility)
I have not found a vendor for exhausts or cams, but its a start.
Now you can do some mods to your existing exhaust and airbox without running too lean.

So do the mods and go kick some Himalayn butt!

https://www.magnumtuning.com/en/detail/ ... ambler-400

Image
2013 Buddy 125, Prima Pipe, #95 main jet, Orange CDI
User avatar
wheelbender6
Member
Posts: 852
Joined: Sun Jul 07, 2013 1:27 am
Location: Houston area

Re: HP ECU for G400C

Post by wheelbender6 »

Those are 9 pin connectors on the version for the Mash. Don't all ECU motorcycles sold in the US require OBD connectors?
If that is the case, better forget the Magnum gadget and put a 1 ohm potentiometer on the wire from the air intake temp sensor.
You can also richen the mixture a bit by placing a resistor in the wire from the O2 sensor.
2013 Buddy 125, Prima Pipe, #95 main jet, Orange CDI
Post Reply