Turn Signal Problem?
Posted: Wed Oct 11, 2017 5:42 pm
So I recently bought a used 2014 roughhouse and quickly decided I wanted to scrap the old fugly turn signals. First I got the rear signals, they’re some black led signals that are much smaller, so I put those on and they worked fine, but flashed a little too fast, which was as I expected. Next I got my front signals and put those on, so once I got them hooked up, I. Turned it on to test them. When I turned them on, the relay flashed so fast that it sounded like buzzing, in fact they were just on, not even flashing. After testing a few times the relay stopped making any noise and then all four turn signals would light up but very dim, no flashing, this would happen if I put on either side or if I had the flashers on. So now I just got in my relay, I think it’s for a car but it’s a 3 pin, and it has a little knob on it to adjust the flash rate. So I wired it up, and now all four signals come on and flash like the hazards if I turn on the indicators in either direction or if I turn on the hazards. I tried playing with the three wires connected to the relay and it doesn’t work at all except how I had it originally connected which I’m pretty sure was correct all along. So now I have no idea what to do.