Page 1 of 1
Buddy 150 front fender removal
Posted: Wed Apr 08, 2015 9:45 pm
by ScooterLou
I need to remove the front fender on my buddy 150. Obviously the two screws on either side need to be removed. But how do I proceed from there? There appears to be two tabs that the front half of the fender needs to be lifted over on the top of the fender? Any suggestions?
Lou
Front Fender
Posted: Wed Apr 08, 2015 11:42 pm
by MYSCTR
There will also be a hard rubber part sticking up through at the top, so you will have to speed the bottoms out on each side to clear the tabs, then roll up on the front and lift (push) upwards to remove the top connection (as I recall).
It would be helpful if you could crawl up in there and see the part I am talking about, yet short of that slide your hand up there and feel for it.
Good Luck!
Posted: Thu Apr 09, 2015 3:56 am
by ScooterLou
I took off the front cover of the scoot and can see the top of the fender. I guess I will try to pry a flathead in there and push down so the bumps clear the tabs. It will have to wait for another day though as I threw out my back so bad just squatting down I am going to have to go to the doctor tomorrow!
