Hooligan headlight adjustment.

theemptythrone · Post by **theemptythrone** » Sat Feb 21, 2015 8:53 pm

Does anybody know how to ajustment the beam height on the hooligan?
I do a lot of night riding and the low beam hs1 is just a tad to low for my liking.

avescoots1134 · Post by **avescoots1134** » Mon Feb 23, 2015 2:08 am

If I remember correctly, the adjuster (philips screw) is on the rear of the headlight. You'll have to remove the front panel.

theemptythrone · Post by **theemptythrone** » Mon Feb 23, 2015 9:01 am

any tips on how to remove it? which screws? pull up/down on the panel ?

im a little nervous about taking panels off the this scoot cause theyres no too much info out there for it.

thank you

avescoots1134 · Post by **avescoots1134** » Mon Feb 23, 2015 3:27 pm

I don't have a Hooligan in the shop right now, but I believe there is two screws behind the panel on each side and one large one in the front. Take these out, wiggle the panel a bit and viola!

I've torn down a Hooligan to replace a harness and they're relatively simple. No tricky/fragile tabs to break or too much hidden hardware.